H-5022 H- 5025 H-5026 H-5035

GL provides a hard alloy blade from sub-micron c-1 to c-8. Pioneer in coating carbide industry, Green leaves provide a wide variety of uncoated, lacquered and painted PHVD – coated grades. Carbide blade can be in ANSI standard geometry and multi – purpose crushing For rough grinding. Coating – CHVD H-5022 a common CHVD coating […]

milling high

CHVD coating is rated in severe machining applications and requires resistance to mechanical shock. G-910 PHVD coating is used for milling high temperature alloy, stainless steel and low carbon steel. G-910 is a medium speed rating and should be used in medium to high feed rate. G- 915 multilayer PHVD coating grade for milling and […]

G-5125 (CHVD coating)

G-5125 (CHVD coating) Suitable for high speed and moderate milling alloy steel. Excellent wear resistance, crater wear, thermal shock, deformation and edge formation Powerlock insert The green leaf Powerlock thread and slot system, tools and toolbars provide a complete carbide blade, in line with the industry’s style, with a notch – style system. In addition, […]

Hushcut series II milling cutter

Hushcut series II milling cutter To make the most of available horsepower, greenliffe’s Hushcut series II milling cutter offers a quiet, free-cutting motion that results in longer tool life and improved surface finishes. The Hushcut II milling cutter USES a high shear tip geometry that can be used in two insert sizes to accommodate the […]

The application information recommended by cutters for rhino feed

Application information The application information recommended by cutters for rhino feed Tools are best suited for “z-level” roughening; Reach the cutting depth (DOC) and remove the entire plane. The use of rhino feed is not recommended. Increase (2 ˚ Max.) Recommend it. The use of a rhino feed tool absolutely requires climbing. In the conventional […]

Operation instructions for small feed inserts

Operation instructions for small feed inserts The operation of small feed insert inserts has the smallest IC (inner circle) and the smallest cross section. These inserts are recommended to run good feed and DOC combinations. Higher feed ranges can be accepted when running a light DOC. When running a heavier DOC, use a lower middle […]

The drill is drilled with a indexable drill

Consider the following. The EHWT has a 5.5-inch diameter hole, mounted on a plate about 4 inches thick, and runs at a 15-horsepower vertical machining center with 40 conical shafts. The machine can reach 1.125 diameter indexable drill without stopping. As EHWT sees, it has four options: The drill is drilled with a indexable drill, […]

EHWT

The EHWT merger (Rockford,IL) has greatly improved its hole making ability by using helical interpolation technique. This concept was introduced to them by the DPA company (Bloomfield,CT) in order to improve the cycle of the new part. Don Busekros, owner of EHWT, explained: “we have an application that can produce new production lines based on […]

cutting using a rounded insert.

With the right tools, even a 10 or 15 horsepower machine can make competitive metal disassembly, thus reducing the installation and greater flexibility of the workshop. Closer to completion A semi – completed or completed cut provides new possibilities for semi-finished or completed cutting using a rounded insert. When using a 90-degree tool for roughing […]

inserts

It should be noted that some button cutter users have problems inserting motions in the pocket of the cutting tool, or when the insertion is worn down. In both cases, the tool pressure increases and the insertion clamping effectiveness is affected. The cutter should include design features that enhance the tool integrity of these applications. […]