Operation instructions for small feed inserts
The operation of small feed insert inserts has the smallest IC (inner circle) and the smallest cross section. These inserts are recommended to run good feed and DOC combinations. Higher feed ranges can be accepted when running a light DOC. When running a heavier DOC, use a lower middle feed range. Insert an index into a prominent garment to avoid breakage.
If I cut. “Try it, doctor.” “The thickness of the chip is doubled.” 007: x = 4. 028 “the.
To compensate:
DPA’s small feeding socket has a 4x dilution factor. .012 compensation FPT recommendation. 032 “represents the actual chip thickness of 0.003-0.008”.
The operation says insert in the Ming
The operation instructions of the feed interpolation insert are more cross-section than small feed, but smaller than large feed. These are good universal insert tools that are best suited for the lightest (40 degrees, linear, etc.) machines. In most cases, run faster feeds with lighter documents. In the heavier DOC, run the feed range in the middle region.
If I cut. “Give it a try, doc.” The thickness of the chip is doubled. 010 “x 5 =. 050 “the.
To compensate:
In DPA, there is a 5x wafer dilution factor. 020 – compensation FPT recommendation. 060 “(” T”) and.015 -. 050 “(” D”) represents the actual chip thickness. 004. 012 “and.003 -. 010 “respectively.
Operation instructions for heavy feed insertion
The operation of the strong insertion type insertion tube has the largest cross section. Heavy feed blades are suitable for heavy DOC and larger machines (50 taper, box type, etc.). For optimal performance, use heavier “light to medium” FPT or lighter DOC.
If I cut. “Give it a try, doc.” The thickness of the chip is doubled. 010 “x 5 =. 050 “the.
To compensate:
The DPA’s heavy feed insertion has a 5x wafer dilution factor. 025 – compensation FPT recommendation. 070 “(” T”) and.020 -. (” D “) represents the actual thickness of the chip. 005. 04 014 -. 011 “respectively.
