Monthly Archives: December 2017

use of tool racks applicable to rough operations: use end mills and power chuck; There is a seam jacket not recommended. suggest The tool is best for the “z-class” roughening; Go deep into the cutting depth (DHOC) and clear the entire hierarchy. the End Mills – crash rate should not exceed. (50 mm/revolution. Each tooth […]

although the cutting knife has a heavy cutting ability, it is important to be aware of the ability to allow the machine to be in power and stiffness. compensate radial chip when cutting width (WHOC) is less than 50% of cutting diameter. the feeding rate should not be significantly below the recommended range, or there […]

Therefore, any metal cutting operation should be performed in a completely closed (shielded) environment to prevent damage from flying objects. After purchase, DPA does not bear any loss, damage or expense of any use or disposal of our products. Grinding produces harmful dust. To avoid adverse health effects, use appropriate ventilation and reading material safety […]

There is a sharper edge (Angle) on the shoulder tool, and excessive vibration creates the potential for whittling, which can lead to catastrophic failure. The button cutter provides good metal removal on less rigid machines for two main reasons. First, the rounded blade is stronger than the sharp square shoulder blade. This greater intensity allows […]

In these cases, the metal removal rate is far greater than the capacity of most of the shoulder tools, but the power consumption will increase proportionally. However, in most cases, when the horsepower is sufficient, the shoulder tool is better than a button cutter. This observation comes from the fact that a square shoulder insertion […]

The wrong answer may result in spending extra time in the rough process, resulting in loss of revenue at work, and, worse, a backup of tasks on the same machine. In addition, using the wrong tool to coarsen causes a headache for the final operation, and it takes an extra time to balance the remaining […]

There is a sharper edge (Angle) on the shoulder tool, and excessive vibration creates the potential for whittling, which can lead to catastrophic failure. The button cutter provides good metal removal on less rigid machines for two main reasons. First, the rounded blade is stronger than the sharp square shoulder blade. This greater intensity allows […]

However, in most cases, when the horsepower is sufficient, the shoulder tool is better than a button cutter. This observation comes from the fact that a square shoulder insertion usually has a cutting edge length of 15-17 mm, which maintains a uniform thickness of the chip in the cross-section of the chip. A key cutter […]

The wrong answer may result in spending extra time in the rough process, resulting in loss of revenue at work, and, worse, a backup of tasks on the same machine. In addition, using the wrong tool to coarsen causes a headache for the final operation, and it takes an extra time to balance the remaining […]

Applications that need a lot of metal removal can be through the use of an aggressive cutting depth and a medium feed to successfully processed, or using a light cutting depth and super aggressive feed. Both achieve high metal removal rates, but also provide different types of machine tools. Older, more powerful machines can respond […]