Turn the heavy

Turn the heavy Ceramic cutting tools, such as the luye gem-7 composite and wg-300 whiskers, combine with a sturdy, well-designed support system to produce a green leaf blade system. carbide GL provides a hard alloy blade from sub-micron c-1 to c-8. As a coating carbide industry pioneer, GL provides a variety of coatings, coatings and […]

H speed

H speed is used. The h-20m A micron c-2 carbide is suitable for the rotation and milling of titanium and nickel-base superalloys. H-20m has strength and edge wear characteristics when high strength material is turned. cermet Greenliff is a leader in the development and manufacture of ceramic and coated ceramics in ANSI standards and special […]

high cutting speed

H-5036 has a unique toughness and heat resistance, which makes it suitable for heavy duty and light milling of high cutting speed. H – 5040 for low speed, high feed of carbon steel and alloy steel, cast iron, cast iron, cast iron, cast iron, cast iron, cast iron, cast iron, cast iron, cast iron, cast […]

H-5022 H- 5025 H-5026 H-5035

GL provides a hard alloy blade from sub-micron c-1 to c-8. Pioneer in coating carbide industry, Green leaves provide a wide variety of uncoated, lacquered and painted PHVD – coated grades. Carbide blade can be in ANSI standard geometry and multi – purpose crushing For rough grinding. Coating – CHVD H-5022 a common CHVD coating […]

milling high

CHVD coating is rated in severe machining applications and requires resistance to mechanical shock. G-910 PHVD coating is used for milling high temperature alloy, stainless steel and low carbon steel. G-910 is a medium speed rating and should be used in medium to high feed rate. G- 915 multilayer PHVD coating grade for milling and […]

G-5125 (CHVD coating)

G-5125 (CHVD coating) Suitable for high speed and moderate milling alloy steel. Excellent wear resistance, crater wear, thermal shock, deformation and edge formation Powerlock insert The green leaf Powerlock thread and slot system, tools and toolbars provide a complete carbide blade, in line with the industry’s style, with a notch – style system. In addition, […]

Hushcut series II milling cutter

Hushcut series II milling cutter To make the most of available horsepower, greenliffe’s Hushcut series II milling cutter offers a quiet, free-cutting motion that results in longer tool life and improved surface finishes. The Hushcut II milling cutter USES a high shear tip geometry that can be used in two insert sizes to accommodate the […]

The application information recommended by cutters for rhino feed

Application information The application information recommended by cutters for rhino feed Tools are best suited for “z-level” roughening; Reach the cutting depth (DOC) and remove the entire plane. The use of rhino feed is not recommended. Increase (2 ˚ Max.) Recommend it. The use of a rhino feed tool absolutely requires climbing. In the conventional […]

Operation instructions for small feed inserts

Operation instructions for small feed inserts The operation of small feed insert inserts has the smallest IC (inner circle) and the smallest cross section. These inserts are recommended to run good feed and DOC combinations. Higher feed ranges can be accepted when running a light DOC. When running a heavier DOC, use a lower middle […]

The drill is drilled with a indexable drill

Consider the following. The EHWT has a 5.5-inch diameter hole, mounted on a plate about 4 inches thick, and runs at a 15-horsepower vertical machining center with 40 conical shafts. The machine can reach 1.125 diameter indexable drill without stopping. As EHWT sees, it has four options: The drill is drilled with a indexable drill, […]